|
Warmup
Settings Help
To save energy, the system can be set up to go into standby mode
periodically. When it is in standby mode, the system can take several minutes
to warm up and become ready to print. To save time, you can use the settings
on this page to warm up the system automatically at specified intervals. To
set warm-up and standby times, select one of the three warm-up modes from the
pull-down menu.
- Intelligent Ready - The
system automatically monitors system usage patterns and follows a warm-up
schedule based on
system usage.
- Job Activated - The
system warms up when it receives a print job.
- Scheduled - You can select
different warm-up and standby settings for each day of the week by entering
these values in
the schedule on this page. For the Standby Settings, if you select Idle
After Timeout, the system goes into standby mode as specified in the
Power Saver Timeout settings below.
Local Date and
Time - Reports
the current setting for the system's clock. Click the link to display the
Date and Time page, where you can make changes to the clock settings.
Fast Resume: This option reduces the time the printer takes to wake up. If you enable this option, the standby time and energy saving default are reduced and energy consumption increases.
|
