Use this page to set community names for SET/GET SNMP queries and traps. Hosts must have these community names defined in their applications to access the printer using SNMP v1/v2c.

Note: If any changes are made to the GET, SET, and Trap Community Names for the printer, then each application that uses the SNMP v1/v2c protocol to communicate with the printer requires a corresponding GET, SET, and Trap Community Name.

Community Names

GET Community Name - Enter the GET Community Name in this field. This name can be a maximum of 32 characters. Click Apply to save the changes, or click Cancel to keep the previous settings and return to the main SNMP Configuration page.

SET Community Name - Enter the SET Community Name to allow a host with this community name to perform SNMP SETS on the printer. This name can be a maximum of 32 characters. Click Apply to save the changes, or click Cancel to keep the previous settings and return to the main SNMP Configuration page.

Trap Community Name - Enter the Trap Community Name to allow a host with this community name to receive traps from printer. This name can be a maximum of 32 characters. Click Apply to save the changes, or click Cancel to keep the previous settings and return to the main SNMP Configuration page.

Traps - Click Configure Traps to add, edit or delete traps for SNMP v1v2c.

Authentication Traps - Select the Enabled checkbox to enable Authentication Traps. This checkbox is cleared (unchecked) by default.