Use the Clone Printer page to copy selected settings from a Source Printer to a Destination Printer on the same network. To clone the selected settings to a Destination Printer in a different domain or zone than the Source Printer, enter the Zone and Domain information in the fields below Optional Settings.

Note: To use the Clone Printer feature, both the Source Printer and Destination Printer must have an IP address, netmask, and default gateway configured, both printers must be the same model, and HTTP must be enabled on the Destination Printer.

Cloning Settings from One Printer to Another

Select the parameters to be cloned from the Source Printer. You can choose any combination of the following settings or you can select all by clicking Check All:

Source Printer Settings

Enter the IP Address or DNS Name of the Destination Printer. If you enter a DNS Name, DNS must be configured on the TCP/IP page.

Optional Settings

You may assign a Printer Name (SNMP System Name) to the Destination Printer by entering this name in the Printer Name (SNMP System Name) field.

Modify the EtherTalk Zone and/or IP Domain Name settings if the Destination Printer will be located in a different Domain / Zone.

Note: EtherTalk Zone and/or IP Domain Name settings will be cloned only if the EtherTalk and/or TCP/IP settings are selected to be cloned above.

Confirm Cloning Settings

When you click Clone Selected Settings, the Confirm Cloning Settings page displays containing your selections. If you are satisfied with the list of settings to clone, click Clone to continue; otherwise click Cancel.