|
SNMP v1/v2c Help
Use this page to set community names for SET/GET SNMP queries
and traps. Hosts must have these community names defined in their applications
to access the printer using SNMP v1/v2c.
Note: If any changes are made to the GET, SET, and Trap
Community Names for the printer, then each application that uses the SNMP v1/v2c protocol to communicate with the printer requires a corresponding GET, SET, and Trap
Community Name.
Community Name
GET Community Name - Enter the GET Community Name in
this field. This name can be a maximum of 32 characters.
SET Community Name - Enter the SET Community Name to allow a host with this community name to perform SNMP
SETS on the printer. This name can be a maximum of 32 characters.
Trap Community Name - Enter the Trap Community Name to allow a host with this community name to receive traps from printer. This name can be a maximum of 32 characters.
Configuration 1-4
- Trap Address Type - Select the IP address type from IPv4, IPv6 or Disable.
- Trap Destination Address - Enter the IP address in this field.
- IPv4 address format is x.x.x.x, where x represents a decimal number from 0 - 255. IPv4 address values must not start with 127 or 224-254.
- IPv6 addresses should be hex code delimited by the : character, and can be up to 39 characters in length.
- Port Number - Enter the Port Number between 0 - 65535 in this field.
- Notify - Select the checkboxes to choose trap types to be sent to the specified address. You can select:
- All Traps
- Printer Traps
- Job Monitoring Traps
- Cold Start Traps
- Warm Start Traps
- Authentication Error Trap
Authentication Error Trap - Select the Enabled checkbox to enable Authentication Traps. This checkbox is cleared (unchecked) by default.
|
