---

Caution: If you are adding a Lower Paper Tray Assembly to a printer that is already in service, let the printer cool down for at least 30 minutes before you move it to allow sufficient time for the ink to solidify. Then remove the maintenance tray, and turn off and unplug the printer.

---

1. Unpack the Lower Paper Tray Assembly.

2. Remove the tray from the Lower Paper Tray Assembly. Remove the shipping block from the tray and replace the tray in the assembly. Refer to Loading the optional Lower Paper Tray Assembly for paper-loading instructions.

3. Place the Lower Paper Tray Assembly where you will install the printer.

   ---

   Note: To ensure proper printer operation, install the printer and Lower Paper Tray Assembly on a flat surface having no more than 3 degrees of tilt. This is approximately equivalent to lifting one side of the printer 2 cm (0.75 in.) off a flat surface.

   ---

4. Place the printer on top of the Lower Paper Tray Assembly.

   ---

   Warning: The printer weighs about 32 kg (70 lb.). Do not attempt to lift the printer without the assistance of another person.

   ---

5. Make sure that the left and right alignment pins fit in the holes in the base of the printer.

6. Plug the Lower Paper Tray Assembly cable into the printer

   .

7. If you are installing a Lower Paper Tray Assembly on a printer already in service, reinsert the maintenance tray, plug the printer back in, and turn the printer on.

   ---

   Warning: The printer is not permanently attached to the Lower Paper Tray Assembly. When moving the printer, first disconnect it from the Lower Paper Tray Assembly and then move each unit separately. Moving the printer incorrectly may cause damage or personal injury.

   ---

• For ordering information, refer to Lower Paper Tray Assembly.