---

Note: You can also control SysStart Job execution from the printer's front panel using the SCSI Startup Mode option in the Printer Defaults menu. See the printer's user manual for instructions on using the printer's front panel.

---

---

Note: The ZDISK SCSI hard disk comes with a Sys/Start job which sets printing parameters to optimize collation. The factory default setting for the Sys/Start job is disabled. To enable the Sys/Start job, download the Set SysStart Job (SYSTART.PS) to the printer.

---

• Macintosh users

• PC and workstation users

1. See Installing the Macintosh utility files to install the printer's software.

2. Locate the Apple Printer Utility in the PhaserTools folder on your hard disk, and double-click its icon to start the application.

3. In the Printer Selector dialog box, make the following selections:
   1. Under AppleTalk Zones, select your printer's zone location.

   2. Under Printers, select your Phaser 360 printer.

   3. Click Open Printer.

      A dialog box appears with the selected zone and printer name at the top.

4. From the File menu, select Send PostScript File. The Select the PostScript files to download dialog box appears.

5. Select the PhaserTools folder.

6. Select one of the following files from the list, and click Add.
   • Use the Set SysStart Job file to enable automatic execution of the SysStart job.

   • Use the No SysStart Job file to disable automatic execution of the SysStart job.

7. Click Send to download the file to the printer.

8. At the prompt Save PostScript output as you are asked for a file name for saving printer output. Use the default name given in the edit box or type in a new name. (Printer output includes status messages generated by the printer reporting such conditions as out of paper.)

9. Click Save.

10. If no output is returned by the printer, the Apple Printer Utility displays a dialog box; click Continue.

    If output is returned by the printer, you won't see this dialog box; check your hard disk for the file created by the utility for the printer's output.

1. Follow the instructions in Installing the PC utility files to install the printer's software.

2. Locate the utility files in the PHSR360 subdirectory inside the PHSRTOOL directory created on your hard disk by the printer's installer.

3. Select one of the following files:
   • Use the SYSTART.PS file to enable automatic execution of the SysStart job.

   • Use the NOSYSTRT.PS file to disable automatic execution of the SysStart job.

4. Use one of the following methods to send the desired file to the printer:
   • PC users: Use the DOS COPY command to send the file to the printer. See Downloading files from a PC if you need instructions.

   • Workstation users: Send a file to the printer as you would any PostScript file.