• PostScript Levels 1, 2 and 3

• Monochrome PCL5e (Printer Command Language), includes HP-GL2 (Hewlett-Packard Graphics Language)

Changing the language of the printer between PostScript and Auto Select (monochrome PCL5 and HP-GL) is port-specific. The ports, such as the parallel port, can each be configured differently. You can change the default language on any port so whenever the printer is turned on it expects to receive PostScript or PCL5 data on a specific port. If automatic language selection is enabled on a particular port, it becomes the default on that port, allowing you to send PostScript and PCL5 files to that port.

Changes to the language on any port remain in effect even if the printer is turned off or reset.

---

Note: Use the following files if the printer is connected directly to your computer through the parallel port. If the printer is shared on a network, use the appropriate printer queues.

---

• PostScript

• Auto Select

1. See Installing the files for instructions on installing the printer's utility files.

2. Locate the PSCRIPT.PS file in the PHSR360 subdirectory inside the PHSRTOOL directory created on your hard disk by the printer's installer.

3. Use one of the following methods to send the PSCRIPT.PS file to the printer:
   • PC users: Use the DOS COPY command to send the file to the printer. See Downloading files from a PC if you need instructions.

   • Workstation users: Send the file to a printer as you would any PostScript file.

1. See Installing the files for instructions on installing the printer's utility files.

2. Locate the AIS.PS file in the PHSR360 subdirectory inside the PHSRTOOL directory created on your hard disk by the printer's installer.

3. Use one of the following methods to send the AIS.PS file to the printer:
   • PC users: Use the DOS COPY command to send the file to the printer. See Downloading files from a PC if you need instructions.

   • Workstation users: Send the file to a printer as you would any PostScript file.