Static electricity precautions

• Leave the printer plugged into its power outlet; this preserves a ground path for static discharges.

• Touch the printer's bare metal frame often to discharge static electricity from your body.

• Handle the circuit board(s) by their edges only.

• Do not lay the board(s) on a metal surface.

• Make the least possible movements to avoid generating static electricity.

• Avoid wearing wool, nylon or polyester clothing; they generate static electricity.

• Jumper at 16 (factory default): 16 Mbps (megabits per second)

• Jumper at 4: 4 Mbps

1. Rear panel

2. Jumper

---

Note: EtherTalk, LocalTalk, and TokenTalk protocols require you to attach the network cable to the printer with the printer powered off. After connection, turn on the printer.

---

1. Power down the printer. Do not unplug the printer; this preserves a ground path to dissipate static charges.

2. Remove the network card cover plate from the rear panel of the printer. Save the mounting screws for use in the next step.

3. Slide the network card into the card slot and firmly push it into place. Secure the card in place with the mounting screws.

4. Connect the appropriate network interface cable to one of the network card's connectors.

5. Turn on the printer and print the Configuration Page; it lists information regarding the network interface. For information on printing the Configuration Page, see The printer's Configuration Page.