Click on the following topics for more information:

• Removing Control-D characters from utility files

• Adding Control-D characters to utility files

1. Locate the delctrld UNIX shell script in the UNIX.TAR file on the Phaser 350 printer's CD-ROM. (Or, see Obtaining the PC utility files to obtain this shell script through another method.)

2. Copy the script to your hard disk.

3. To remove all Control-D characters from a file, type the following command:
   delctrld filename1.ps filename2.ps

   where filename1.ps is the utility file you want to remove Control-D characters from, and filename2.ps is the revised file with a new name. (Both filename1.ps and filename2.ps can have the same name, but the original file will be overwritten by the revision.)

   Send the utility file to the printer as you would any PostScript file.

1. Locate the addctrld UNIX shell script in the UNIX.TAR file on the Phaser 350 printer's CD-ROM. (Or, see Obtaining the PC utility files to obtain this shell script through another method.)

2. Copy the script to your hard disk.

3. To add Control-D characters to the beginning and end of a file, type the following command:
   addctrld filename1.ps filename2.ps

   where filename1.ps is the utility file you want to add Control-D characters to, and filename2.ps is the revised file with a new name. (Both filename1.ps and filename2.ps can have the same name, but the original file will be overwritten by the revision.)

   Send the utility file to the printer as you would any PostScript file.