Click on the following topics for more information:

• Required items

• Important guidelines

• Connecting one disk

• Connecting multiple disks

• A SCSI peripheral cable for each disk.
  The printer uses a SCSI-2, 50-pin connector. See the printer's user manual if you need a 50-pin connector.

• One SCSI cable terminator, unless one of your disks has an internal terminator.

• The printer can support up to seven external disks.

• You must turn on the disk(s) before you turn on the printer. Wait at least one minute after turning on the disk(s) before turning on the printer.

• Terminators:
  • The printer must always be at one end of the chain with a terminator at the other end (or a terminated device such as the Phaser Copystation).

  • The printer has an internal terminator.

• SCSI ID numbers:
  • With multiple disks, each disk must have a unique SCSI ID number. Do not turn on the printer or disk until each disk has a unique number.

  • The printer's SCSI number is 7. Valid ID numbers for the external disk are 0 through 6.

    ---

    Note: If you have a Phaser Copystation connected to the printer, it must be located at one end of the SCSI chain, with the printer at the other end and the external disk(s) in the middle. The Copystation uses two SCSI ID addresses, 05 and 06; therefore, the external disk(s) can use ID numbers 0 through 4. If you set an external disk to SCSI ID address 05 or 06, you may see an error on the configuration or startup pages.

    ---

• Sys/Start file:
  • You may load a startup file called Sys/Start onto your external disk. The Sys/Start job file is similar to an init file. When you turn on the printer the file executes, providing that Sys/Start has been enabled through a control file downloaded to the printer. Refer to Enabling and disabling SysStart Job execution for more information.

  • With multiple disks, only one disk can contain a Sys/Start file.

    ---

    Note: If the Sys/Start file contains an error, the printer ignores the remainder of the file and may not start up as expected.

    ---

• Format and initialize:
  • Unless the disk is already formatted for operation with a PostScript printer, you have to format and initialize the disk after connecting it to the printer.

  • Refer to Formatting a SCSI hard disk and Initializing a formatted SCSI hard disk after connecting a hard disk.

---

Caution: To avoid damaging components, turn off the printer, an external disk, and a CopyStation if you have one, before you connect or disconnect a SCSI cable. Turn on the disk, and CopyStation if you have one connected, before you turn on the printer.

---

1. SCSI port

2. External disk SCSI port

3. Terminator (not required if the disk has a built-in terminator or if you have a Phaser Copystation connected at the other end of the chain).

---

Caution: To avoid damaging components, turn off the printer and external disk before you connect or disconnect a SCSI cable. Turn on the disks before you turn on the printer.

---

• Each disk must have a unique SCSI ID number. Do not turn on the printer or disk until each disk has a unique number.

• The printer must always be at one end of the chain with a terminator at the other end.

• Only one disk can contain a Sys/Start file.

1. SCSI port

2. External disks

3. Terminator (not required if the end disk has a built-in terminator if you have a Phaser Copystation connected at the other end of the chain). The middle disk must not have an internal terminator).