Printers & Supplies
Solutions & Services
Customer Support
Partners
Note: When you are in the menu, if the front panel is not used for 5 minutes, the printer returns to the Ready state., Enter the Network Settings menu by pressing the right (---->) or left (<----) arrow buttons until the front panel displays Network Settings.
Note: When you are in the menu, if the front panel is not used for 5 minutes, the printer returns to the Ready state.,
Press the Menu button until the front panel displays TCP/IP:enabled or TCP/IP:disabled.
If TCP/IP is disabled, press the right (---->) arrow button until the front panel displays TCP/IP:enabled, then press the OK button. The front panel briefly displays Selected, then the front panel displays the following message:
TCP/IP <----- -----> Menu
Press the Menu button until the front panel displays TCP/IP:enabled.
TCP/IP:enabled
TCP/IP: enabled
Ready
Processing data
Note: If you are too slow in pressing the right and left arrow buttons, the front panel display reverts to the TCP/IP message in Step 3; go back to Step 3 and try again.
IP is 000.000.000.000 Change OK
Note: The IP address displayed on your printer may be different than the one in this example. Setting the IP address to 000.000.000.000 causes the printer to use Dynamic Address Resolution to set its IP address (see Setting IP parameters: RARP or BOOTP). Press the Change button; the front panel displays the following message:
Note: The IP address displayed on your printer may be different than the one in this example. Setting the IP address to 000.000.000.000 causes the printer to use Dynamic Address Resolution to set its IP address (see Setting IP parameters: RARP or BOOTP).
000.000.000.000 Increment Shift Select
Press the Increment button to set the left-most digit of the address.
Press the Shift button to advance to the next digit. Press the Increment button to set this digit.
Use the Shift and Increment buttons as described in Step 8 to set the remaining digits.
When the address is correctly set, press the Set button to enter your settings into the printer; the front panel briefly displays IP Address set, then returns to Ready. The IP address is now set in the printer.
