---

Note: When you are in the menu, if the front panel is not used for 5 minutes, the printer returns to the Ready state.

---

1. Press the Menu button again; the front panel displays Interface.

2. Press the right (---->) arrow button to display TCP/IP Address.

   ---

   Note: If the TCP/IP protocol is disabled, pressing the right (---->) arrow button will have no effect.

   ---

3. Press the Menu button to display the IP address. For example:
   000.000.000.000

   Increment Shift Set

   ---

   Note: The IP address displayed on your printer may be different than the one in this example. Setting the IP address to 000.000.000.000 causes the printer to use Dynamic Address Resolution to set its IP address (see Setting IP parameters: RARP or BOOTP.

   ---

   Press the Increment button to set the left-most digit of the address.

   Press the Shift button to advance to the next digit. Press the Increment button to set this digit.

   Use the Shift and Increment buttons as described in Step d to set the remaining digits.

   When the address is correctly set, press the Select button to enter your settings into the printer; the front panel displays:

   Confirm Selection

   Confirm

   ---

   Note: When you press the Confirm button to set the IP address, the printer resets the network mask and broadcast address to the printer's defaults; see Printer defaults for network mask and broadcast address.

   ---

   Press the Confirm button; the front panel briefly displays Selected, then displays the IP address again. The IP address is now set in the printer.

   Press the Exit button to return to the menu of IP addressing parameters.

1. Press the right arrow (---->) button until Network Mask is displayed.

2. Press the Menu button; the front panel displays the network mask.

3. Use the Increment and Shift buttons as described in Steps 4c through 4f to set the network mask.

4. When the network mask is set, use the Select and Confirm buttons as described in Steps 4g and 4h to enter the network mask into the printer.

5. Press the Exit button to return to the menu of IP addressing parameters.

1. Press the right arrow (---->) button until Gateway Address is displayed.

2. Press the Menu button; the front panel displays the gateway address.

3. Use the Increment and Shift buttons as described in Steps 4c through 4f to set the gateway address.

4. When the gateway address is set, use the Select and Confirm buttons as described in Steps 4g and 4h to enter the gateway address into the printer.

1. Press the right arrow (---->) button until Broadcast Address is displayed.

2. Press the Menu button; the front panel displays the broadcast address.

3. Use the Increment and Shift buttons as described in Steps 4c through 4f to set the broadcast address.

4. When the broadcast address is set, use the Select and Confirm buttons as described in Steps 4g and 4h to enter the broadcast address into the printer.