---

Note: When you set the IP addressing parameters from the front panel, the front panel selections for DHCP/BOOTP and RARP are automatically set to Disabled.

---

1. Press the Menu button; the front panel displays Help Pages.

   ---

   Note: When you are in the menu, if the front panel is not used for 5 minutes, the printer returns to the Ready state.

   ---

2. Press the right (---->) or left (<----) arrow buttons until the front panel displays Network Settings.

3. Press the Menu button until the front panel displays TCP/IP.

4. To set the IP address:
   1. Press the Menu button again; the front panel displays Enable Interface.

   2. Press the right (---->) arrow button until the front panel displays TCP/IP Address.

   3. Press the Menu button to display the IP address. For example:
      000.000.000.000

      Increment Shift Select

      ---

      Note: The IP address displayed on your printer may be different than the one in this example.

      ---

      Press the Increment button to set the left-most digit of the address.

      Press the Shift button to advance to the next digit. Press the Increment button to set this digit.

      Use the Shift and Increment buttons as described in Step e to set the remaining digits.

      When the address is correctly set, press the Select button to enter your settings into the printer; the front panel displays:

      Confirm Selection

      Confirm

      Press the Confirm button; the front panel briefly displays Selected, then displays the IP address again. The IP address is now set in the printer.

      Press the Exit button to return to the menu of IP addressing parameters.

5. To set the network mask:
   1. Press the right arrow (---->) button until Network Mask is displayed.

   2. Press the Menu button; the front panel displays the network mask.

   3. Use the Increment and Shift buttons as described in Step 4d and 4e to set the network mask.

   4. When the network mask is set, use the Select and Confirm buttons as described in Steps 4g and 4h to enter the network mask into the printer.

   5. Press the Exit button to return to the menu of IP addressing parameters.

6. To set the gateway address:
   1. Press the right arrow (---->) button until Gateway Address is displayed.

   2. Press the Menu button; the front panel displays the gateway address.

   3. Use the Increment and Shift buttons as described in 4d and 4e to set the gateway address.

   4. When the gateway address is set, use the Select and Confirm buttons as described in Steps 4g and 4h to enter the gateway address into the printer.

7. The printer calculates the broadcast address based on the IP address and the network mask as described under Printer defaults for network mask and broadcast address. In most cases, this calculated value is correct and there is no need to set the broadcast address. However, the broadcast address can be viewed and set using the following procedure:
   1. Press the right arrow (---->) button until Broadcast Address is displayed.

   2. Press the Menu button; the front panel displays the broadcast address.

   3. Use the Increment and Shift buttons as described in 4d and 4e to set the broadcast address.

   4. When the broadcast address is set, use the Select and Confirm buttons as described in Steps 4g and 4h to enter the broadcast address into the printer.

8. Return the printer to normal operation.
   1. Press the Exit button until the front panel displays Network Settings.

   2. Press the Exit button again.
      • If you have changed any parameters that require a printer reset to take effect, you will be prompted to reset the printer. If you press the Reset button, the printer resets. If you press the Resume button, the front panel displays Network Settings. Press the Exit button; the printer returns to normal operation, but the changes you have made will not take effect until the next time the printer is reset.

      • If you have not changed any parameters that require a printer reset to take effect, the front panel displays Ready.