After your network configuration is complete, you may want to disable protocols that you are not using to avoid unnecessary network traffic. There are four ways to disable protocols:

• Use the printer's front panel; see Disabling protocols: front panel.
• Use the PhaserShare Administrator, if you are running NetWare; see Disabling protocols: PhaserShare Administrator.
• With a TCP/IP connection and a World Wide Web browser, you can use PhaserLink software; see Disabling protocols: PhaserLink software.
• Send the appropriate PostScript utility file to the printer; see Disabling protocols: utility files.

The procedures given here for disabling protocols only apply to EtherTalk and TokenTalk installations (using a PhaserShare Series B Ethernet or Token Ring card). The PhaserShare Series B LocalTalk card does not support the protocols discussed here, so they cannot be enabled or disabled.

You can enable protocols by the same procedures; just select the command to enable a protocol rather than disable it.