---

Note: If you are attempting to perform any front panel procedure and you don't see the expected menu choices on the front panel display, the front panel may be locked. For information on how to unlock it, see If the front panel is locked.

---

1. Press the Menu button; the front panel displays Help Pages.

   ---

   Note: When you are in the menu, if the front panel is not used for 5 minutes, the printer returns to the Ready state.

   ---

2. Enter the Network Settings menu by pressing the right (---->) or left (<----) arrow buttons until the front panel displays Network Settings.

3. Press the Menu button; the front panel displays TCP/IP.

4. To disable TCP/IP:
   1. Press the Menu button; the front panel displays Interface.

   2. Press the Menu button again to display the current status of the protocol: Interface:enabled or Interface:disabled. The current status is marked with an asterisk (*) in the upper-right corner of the display.

   3. Press the right arrow (---->) button until the front panel displays Interface:disabled.

   4. Press the OK button to disable the protocol; the front panel briefly displays Selected, then it displays TCP/IP.

5. Disabling EtherTalk. To return the printer to normal operation, go immediately to Step 8; to continue and disable the EtherTalk protocol, follow these steps:
   1. Press the Menu button; the front panel displays EtherTalk.

   2. Press the Menu button again; the front panel displays Interface.

   3. Press the right arrow (---->) button to display the current status of the protocol: Interface:enabled or Interface:disabled. The current status is marked with an asterisk (*) in the upper-right corner of the display.

   4. Press the right arrow (---->) button until the front panel displays Interface:disabled.

   5. Press the OK button to disable the protocol; the front panel briefly displays Selected, then it displays EtherTalk.

6. Disabling NetWare. To return the printer to normal operation, go immediately to Step 8; to continue and disable the NetWare protocol, follow these steps:
   1. Press the Menu button; the front panel displays NetWare.

   2. Press the Menu button again; the front panel displays Interface.

   3. Press the right arrow (---->) button to display the current status of the protocol: Interface:enabled or Interface:disabled. The current status is marked with an asterisk (*) in the upper-right corner of the display.

   4. Press the right arrow (---->) button until the front panel displays Interface:disabled.

   5. Press the OK button to disable the protocol; the front panel briefly displays Selected, then it displays NetWare.

7. Disabling HTTP. To return the printer to normal operation, go immediately to Step 8; to continue and disable the HTTP protocol, follow these steps:
   1. Press the Menu button; the front panel displays HTTP.

   2. Press the Menu button again; the front panel displays Interface.

   3. Press the right arrow (---->) button to display the current status of the protocol: Interface:enabled or Interface:disabled. The current status is marked with an asterisk (*) in the upper-right corner of the display.

   4. Press the right arrow (---->) button until the front panel displays Interface:disabled.

   5. Press the OK button to disable the protocol; the front panel briefly displays Selected, then it displays HTTP.

8. To return the printer to normal operation, press the Exit button until the front panel displays Ready.