System Name

This field allows you to specify the printer's name.

This parameter can also be set from the View and Configure Status Notification (Email Notification) page and the View and Configure PhaserLink Remote Internet Printing Settings page.

System Contact

This field allows you to specify the name of the contact person for printer problems.

This parameter can also be set from the View and Configure Status Notification (Email Notification) page and the View and Configure PhaserLink Remote Internet Printing Settings page.

System Location

This field allows you to specify the printer's location.

This parameter can also be set from the View and Configure Status Notification (Email Notification) page and the View and Configure PhaserLink Remote Internet Printing Settings page.

Trap Host(s)

Phaser 840, 740, 780, and 360 printers: This field allows you to specify the IP or IPX addresses of the members of the trap host list. The addresses must be specified as follows:

IP addresses must be preceded by a 1: 1 xxx.xxx.xxx.xxx

IPX addresses must be preceded by a 0: 0 xxxxxxxxyyyyyyyyyyyy

In IPX addresses, xxxxxxxx is the hexadecimal network address and yyyyyyyyyyyy is the hexadecimal node address. The network and node addresses can be abbreviated by removing any leading zeros.

With Phaser 840, 740 and 780 printers, you can enter IP host names, up to a maximum of 255 characters. IP host names must be preceded by a 1.

Phaser 380, 350, 340, 560, 550, and 600 printers: This field allows you to specify the IP addresses of the members of the trap host list.

Members of the trap host list receive asynchronous SNMP traps (error and status messages) from the printer. Multiple hosts can be specified by separating the addresses with a space.

Authentication Failure Enabled

Enable this if you want to be notified if unauthorized users attempt to set SNMP variables.